Cirrus-logic AN118 Manual do Utilizador descarregar pdf (Página 25)

AN118

AN118REV2 25

else

toggle_two_leds(); /* Test Failed */

break;

/* Test Mode 3: This test lights the first two LED and then

repeatively iniates a conversion and reads it from the serial port. */

case 0x03:

RESET = 0x00;

COMM = 0x00;

while(1)

read_conversion(0x80);

break;

/* Test Mode 4: This test lights the third LED’s. Then it

continuously write to the Gain Registers of PC1. */

case 0x04:

GAIN_CAL = 0x00;

while(1)

write_to_register(0x02,0xAA,0xAA,0xAA);

break;

/* Test Mode 5: This test lights the odd LED’s. Then it

continuously reads the gain register of PC1. */

case 0x05:

RESET = 0x00;

GAIN_CAL = 0x00;

while(1)

read_register(0x0A); /* Read Gain Register of PC1 */

break;

/* Test Mode 6: This test mode tests the RS232 link.

it receives three bytes from the PC and echoes them

back. This PC determines if the test passed. The last

three LED’s are lit to indicate this test mode. */

case 0x06:

COMM = 0x00;

GAIN_CAL = 0x00;

low_byte = RXSER(); /* Receive low byte from PC */

mid_byte = RXSER();

high_byte = RXSER();

TXSER(low_byte); /* Transfer bytes back to PC */

TXSER(mid_byte);

TXSER(high_byte);

toggle_all_leds();

break;

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários

Cirrus-logic AN118 Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Cirrus-logic AN118